Table of Contents
12/2/20
FM MANUAL.DOCX
Table of Contents
Copyright 2020, Vestil Manufacturing Corp.
Page 9 of 20
STEP 7. Weld the bumper boxes to the dock edge. Apply a continuous weld across the top and down both
sides of each bumper box as far as the bottom of the steel dock edge.
Proceed to Step 27
to complete the installation (p. 13).
STEP 8 (docks with a steel edge less than 6”). Measure the height of the dock, from the edge of the dock to
the driveway surface below the dock edge.
Height of dock edge is 50”±1”,
…
…
…
Proceed to Step 9
Height of dock edge is less than 50” …
…
…
Installation not recommended
STEP 9. Remove all material and protrusions from the face of the dock.
STEP 10. Center the leveler in the doorway of the dock, with the top edge of the mounting plate even with the
edge of the dock or the approach ramp (if installed). Tack weld the mounting plate at each end.
