Table of Contents
12/2/20
FM MANUAL.DOCX
Table of Contents
Copyright 2020, Vestil Manufacturing Corp.
Page 12 of 20
STEP 21. Set the approach plate on the dock surface, Place its beveled edge in the groove. Adjust plate
position so that the opposite edge is flush with the dock face. Then, anchor the plate to the floor with six ¾” x
5” anchor bolts. Do not tighten the bolts at this time.
STEP 22. Tack-weld the mounting plate to the approach plate at both ends. The tops of the mounting plate and
approach plate should be flush and level. Have a qualified welder apply a continuous weld between the
mounting plate and the edge of the approach plate. Chip and grind as required.
STEP 23. Use four ¾”×5” anchor bolts with four ¾” flat washers to attach the dock leveler to the dock face. Do
not tighten the bolts at this time.
