9
DIGITAL EQUALIZER
PRE EQ LEVEL
1.
Press the EQ button and select PRE EQ (Pre EQ Level). The PRE EQ LED lights up and
bargraph shows the pre EQ levels of each track. Select the track to adjust the level. The
selected track LED lights up. The counter shows the level value of the selected track with
dB.
The maximum level is shown as +6dB and goes down to -57.5dB to off.
2.
Adjust the level by using the Jog Dial.
TechTip
Pre EQ level adjustment is used to decrease the level when the playback signal is
boosted by EQ and exceeds the maximum level as indicated by the red peak LED If
the
signal exceeded the peak during recording, decreasing pre EQ level does not
eliminate the
distortion. Regular level adjustment is done by adjusting the VOL
(volume). If no track is
distorting, pre EQ level should be set to the 0dB position.
EQ
The EQ section operates just like any normal EQ. There is HIGH, LOW, and PARAMETRIC
MIDS, consisting of Mid Level, Mid Frequency, and Mid Q.
1.
Press the EQ button and select the parameter from High, Mid, Mid Frequency , Mid Q, or
Low. Selected parameter LED lights up. Bargraph shows the value of each track.
2.
Select the track to adjust the level or frequency. Selected track LED lights up. The counter
shows the value of the selected track with dB or Hz. The EQ level is adjusted from +12dB to
0dB
to -12dB. The mid frequency is adjusted from 500Hz to 2000Hz (2KHz) in 9 steps.
3.
Adjust the level or frequency by using the Jog Dial.
TechTip
- When some frequencies are boosted by EQ, the playback level may exceed
the peak level. In this case, PRE EQ LEVEL should be decreased so that the
playback level does not distort.
