Program Channel
Each of the 16 Program Channels for the HDR can be recalled by
sending the HDR a MIDI Program Change message. In order to receive these
messages, the HDR must be set to the same MIDI channel as the messages are
transmitted on. To set Program channel assignment, follow these steps.
1.
Press the UTILITY button until MIDI is selected. The display shows
"Pro cH".
Press the ENTER button.
2.
Use the Jog Dial to select the MIDI channel that matches the transmitting
channel. Press the ENTER button.
TechTIp:
There are two additional choices listed,
" cH ALL",
and
"ChnonE".
Channel All will respond to program changes on all MIDI channels.
If Program Change messages are being transmitted on more than
one channel, this setting will produce unpredictable results.
If Channel None is selected all Program Change messages will be ignored.
3.
The display shows "done" and displays the current location.
Continuous Controller Channel
Every parameter of the internal mixer can be controlled by sending
CC messages to the HDR In order to receive these messages, the HDR
must be set to the same MIDI channel as the messages are transmitted on.
1.
Press the UTILITY button until MIDI is selected.
Use the Jog Dial to select
" CC ch".
Press the ENTER button.
2.
Use the Jog Dial to select the MIDI channel that matches the transmitting channel.
Press the ENTER button.
Note: There are two additional choices listed,
" cH ALL"
, and
"ChnonE
".
Channel All will respond to program changes on all MIDI channels.
If Program Change messages are being transmitted on more than one channel,
this setting will produce unpredictable results. If Channel None is selected
all Program Change messages will be ignored.
3.The display shows "done" and displays the current location.
