83
147 – Sensor Supervision Failure
When MZ-1/8 fails to receive the signal transmitted from any one of the devices
individually for a preset period.
151 – Gas
154 – Water leakage
When a Water Sensor or Door Contact set as
Wate
r is triggered.
158 – High Temperature
When the temperature exceeds High Temperature setting.
159 – Low Temperature
When the temperature drops below Low Temperature setting.
162 – CO detector
301 – AC Failure
When the AC power fails for more than 10 sec.
302 – Low Battery
When the Control Panel is under low battery.
311 – Panel Battery Missing/Dead
When the Control Panel Battery is missing or disconnected.
344 – Interference
374 – Arm with Fault
When fault exists in system, and the system is armed by confirming the arm action.
(Arm Fault Type set to Confirm.)
380 – Device AC Failure
When an AC power accessory device loses the AC power connection.
383 – Device Tamper
When a device’s tamper switch is triggered.
384 – Device Low Battery
When a device’s is under low battery.
389 – Self Test Failure
400 – Arm/Disarm (by Remote Controller)
When the system is armed or disarmed by using the Remote Controller.
401 – Arm/Disarm by Panel
When the system is armed or disarmed by entering the PIN code.
408 – Set/Unset Disarm
407 – Disarm/Away Arm/Home Arm by Remote Keypad
456 – Home Arm
465 – Alarm Reset
570 – Zone Bypass
When fault exists in system, and the system is armed by ignoring the fault event. (Arm
Fault Type set to Direct Arm)
