background image

Leak Alert

™ 

+

Electronic Water Detector

Undetected water can cause thousands of dollars in

damage. Protect your home from potential water damage

by keeping a Leak Alert

+

 water detector anywhere

flooding is a potential danger—near aquariums,

sump pumps, plumbing, washing machines, water heaters,

toilets, basements, and garages.

1. INSTALLING THE BATTERY

Insert a coin between top  

and bottom halves of case.  

Turn coin to separate.

Connect 9V  

battery to clip. 

Position battery according to the diagram on  

the right. Proper battery position will allow  

the unit to float in the event of a flood.  

Securely close case. 

2. TESTING

Wet your finger and touch the two  

sensing contacts.

A loud, repetitive series of  

beeps will sound and the LEDs  

will flash red. Dry the  

contacts to stop the alarm.

In the event of low battery, 

water detector will chirp (short beep  

every five seconds). Please replace 

with brand new 9V battery immediately.

3. PLACEMENT

Place Leak Alert

+

 water  

detector facing up and  

flat against the surface,  

with metal sensing  

contacts down.

Leak Alert

+

 water  

detector will not  

function properly  

with contacts up.

4. FLOODING

Leak Alert

+

 water detector  

will float (if battery is  

inserted according to  

diagram inside battery  

compartment) and alarm  

will sound for life of  

battery, up to 72 hours.

5. HELPFUL HINTS

Alarm

Sensing Contacts

Flashing LEDs

Battery Access

  Situation  Probable Cause 

Solutions

Alarm sounds,  

but there is no  

water present.

Unit does not sound 

alarm even when 

touching water.

Unit does not float.

• Battery voltage is low.

• Water detector is on 

a conductive surface 

(i.e. metal).

• Ambient moisture 

has collected on 

metal contacts. 

• Metal contacts are 

up, not having direct 

contact with water.

• Battery is dead.

• Battery is not placed in 

correct area of case.

• Change the battery.

• Place a piece of thin paper 

or plastic between water 

detector and metal surface.

• Wipe metal contacts dry. 

• Make sure metal contacts 

are flat on surface where 

water is to be detected.

• Replace battery. 

• Place unit in face-up 

position, open battery 

compartment, and position 

battery per diagram.

REPLACE BATTERY AND RETEST UNIT ANNUALLY.

Leak Alert and Zircon are registered trademarks or trademarks of Zircon Corporation.

Visit www.zircon.com/support  
for the most current instructions.

LIMITED 1 YEAR WARRANTY

Zircon Corporation, (“Zircon”) warrants this product to be free from defects in  
materials and workmanship for one year from the date of purchase. Any in-warranty 
defective product returned to Zircon*, freight prepaid with proof of purchase date  
and $5.00 to cover postage and handling, will be repaired or replaced at Zircon’s  
option. This warranty is limited to the electronic circuitry and original case of the  
product and specifically excludes damage caused by abuse, unreasonable use  
or neglect. This warranty is in lieu of all other warranties, express or implied,  
and no other representations or claims of any nature shall bind or obligate Zircon.  
Any implied warranties applicable to this product are limited to the one year period 
following its purchase. IN NO EVENT WILL ZIRCON BE LIABLE FOR ANY SPECIAL, 
INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM POSSESSION,  
USE OR MALFUNCTION OF THIS PRODUCT.
In accordance with government regulations, you are advised that: (i) some states  
do not allow limitations on how long an implied warranty lasts and/or the exclusion 
or limitation of incidental or consequential damages, so the above limitations  
and/or exclusions may not apply to you, and further. (ii) this warranty gives you  
specific legal rights and you may also have other rights which vary from state  
to state. Return product freight prepaid with proof of purchase date (dated sales 
receipt) and $5.00 to cover postage and handling, to:
Zircon Corporation 
*Attn: Returns Department 
1580 Dell Avenue 
Campbell, CA 95008-06992 USA
Be sure to include your name and return address. Out of warranty service and repair, 
where proof of purchase is not provided, shall be returned with repairs charged 
C.O.D. Allow 4 to 6 weeks for delivery. 
Customer Service: 1-800-245-9265 or 1-408-963-4550 
Monday–Friday, 8:00 a.m. to 5:00 p.m. PST  
[email protected] • www.zircon.com

© 2015 Zircon Corporation • P/N 66912 • Rev A 04/15 

EN

ZirconCorporation

ZirconTV

ZirconTools

 | 

ZirconToolPro

ZirconTools

9V Battery

Отзывы: