1 - 4
Switching on your Vertu phone
S W I T C H I N G O N Y O U R V E R T U
P H O N E
If your battery requires charging, a
battery low
message is displayed when you first switch on your
Vertu phone. Refer to for more information.
Contact with the antenna affects call quality and
may cause the phone to operate at a higher power
level than otherwise needed. Avoiding contact with
the antenna area when operating the phone
optimises the antenna performance and battery life.
E N T E R I N G YO U R P I N C O D E
Depending on your SIM card settings, you may be
prompted to enter a PIN (Personal Identification
Number) code when you switch on your Vertu
phone. This code is used to protect access to your
SIM card and is independent of your Vertu phone.
If you used your SIM card in another phone
previously, the code will be the same.
S E T T I N G T H E T I M E A N D D A T E
If the time and date are not set, you are prompted
to enter your time settings when you first switch on
your Vertu phone.
If your Vertu phone was purchased at a Vertu store,
the time and date should already be set for you.
To set the time and when you switch on your Vertu
phone for the first time:
You can enter the time in either 12-hour (AM/PM)
format or 24-hour format.
For example, to set the time to 08:30:
>
Key in “8”.
>
Scroll to minutes. The leading zero is added to
the hour figure.
>
Key in “30”.
>
Press
ok
.
Or, to set the time to 12:30:
>
Key in “12”. The cursor automatically jumps to
the minutes.
>
Key in “30”.
>
Press
ok
.
>
Press and hold the
P O W E R
key (
01
) for a
few seconds until the
display activates to
switch on your Vertu
phone.
>
Your Vertu phone has
an internal antenna
located inside the top-
rear panel (
02
). Do not
touch the antenna
unnecessarily when
phone is switched on.
>
Use the
N U M B E R
keys
to key in your PIN code.
>
Press
ok
.
It is recommended that you activate both
the PIN code and security code to help
prevent unauthorised use of your SIM card
and your Vertu phone. Refer to the
“Security” chapter for more information.
01
02
We recommend setting the time and date
immediately to ensure that features which
use the time and date, for example the
agenda, operate correctly.
>
Use the
N U M B E R
keys
to key in the correct
time.
>
Use the
S C R O L L
keys to
toggle between hours
and minutes.
Usermanual_en.book Page 4 Wednesday, January 7, 2004 5:55 PM
