VX-150 O
PERATING
M
ANUAL
6
S
WITCHING
P
OWER
O
N
AND
O
FF
Be sure the battery pack is installed.
Connect the antenna to the top panel
ANTENNA
jack.
Switch on the transceiver by rotating the
VOL
con-
trol clockwise out of the click-stop (a momentary
beep will sound).
A
DJUSTING
THE
V
OLUME
L
EVEL
Rotate the
VOL
control (immediately to the right of the Antenna) to set the desired audio
level. Clockwise rotation increases the volume level.
S
QUELCH
S
ETUP
Set the
SQL
control fully counterclockwise, rotate the
VOL
control out of the click-stop and adjust for a com-
fortable volume on the noise or received signal. The
BUSY/TX
indicator LED should glow green. If a sig-
nal is present, rotate the
DIAL
selector on the top panel
to a channel where only noise is heard.
Adjust the
SQL
control just to the point where the noise is silenced and the LED is extin-
guished. If the
SQL
control is set further clockwise, sensitivity to weak signals will be
reduced. Now, whenever a signal reaches the receiver that is strong enough to open the
squelch, the indicator will glow green.
T
RANSMITTING
When you wish to transmit, wait until the channel is clear (
BUSY/TX
lamp off), and squeeze
the
PTT
switch. During transmission the
BUSY/TX
indicator glows red, and relative trans-
mitter power output is indicated graphically along the bottom of the display. Release the
PTT
switch to receive.
If using a “B” version (in Europe), press the
T-CALL
switch (just below the
PTT
switch)
to transmit a 1750 Hz tone to access repeat-
ers that require it.
Basic Operation
Содержание VX-150
Страница 41: ...VX 150 OPERATING MANUAL 39 Notes ...
Страница 42: ...VX 150 OPERATING MANUAL 40 Notes ...