VX-150 O
PERATING
M
ANUAL
23
A
UTOMATIC
L
AMP
I
LLUMINATION
ON
S
CAN
S
TOP
The
VX-150
will automatically illuminate the LCD Lamp whenever the scanner stops on a
signal (the default condition for this feature is “ON”).
The procedure for disabling the Scan Lamp is:
Press the [
F
] key, then press the [
0
(
SET
)] key, to enter the Set mode.
Rotate the
DIAL
to select Menu #8 (“
SCN LMP
”).
Press the [
F
] key to enable changing of this Menu item.
Rotate the
DIAL
to set this Menu item to OFF.
When you have made your selection, press the
PTT
key to save the new setting and exit
to normal operation.
B
AND
E
DGE
B
EEPER
The
VX-150
will automatically “beep” when a band edge is encountered during scanning
(either in standard VFO scanning or during PMS operation). You may disable this feature,
if it is annoying, without disabling the keypad beeper (the default condition for this feature
is “ON”.
The procedure for disabling the Band-Edge Beeper is:
Press the [
F
] key, then press the [
0
(
SET
)] key, to enter the Set mode.
Rotate the
DIAL
to select Menu #17 (“
EDGE BP
”).
Press the [
F
] key to enable changing of this Menu item.
Rotate the
DIAL
to set this Menu item to OFF.
When you have made your selection, press the
PTT
key to save the new setting and exit
to normal operation.
S
MART
S
EARCH
O
PERATION
The Smart Search feature allows you to load frequencies automatically according to where
activity is encountered by your radio. When Smart Search is engaged, the transceiver will
search above and below your current frequency, storing active frequencies as it goes (with-
out stopping on them even momentarily); these frequencies are stored into a special Smart
Search memory bank, consisting of 31 memories (15 above the current frequency, 15 be-
low the current frequency, plus the current frequency itself).
Two basic operating modes for Smart Search are available:
SINGLE
:
In this mode, the transceiver will sweep the current band once in each direc-
tion starting on the current frequency. All channels where activity is present
will be loaded into the Smart Search memories; whether or not all 31 memo-
ries are filled, the search will stop after one sweep in each direction.
CONTINUE
: In this mode, the transceiver will make one pass in each direction as with
One-Shot searching; if all 31 channels are not filled after the first sweep,
however, the radio will continue sweeping until they are all filled.
Scanning
Содержание VX-150
Страница 41: ...VX 150 OPERATING MANUAL 39 Notes ...
Страница 42: ...VX 150 OPERATING MANUAL 40 Notes ...
