FCC ID: K66FT-857
Operating Manual
Vertex Standard Co., Ltd.
69
Default: 0 Hz
MENU MODE No
x
018 [CAR USB T]
Function: Sets the Tx Carrier Point for USB
Available Values: –300 ~ +300 Hz
Default: 0 Hz
MENU MODE No
x
019 [CAT RATE]
Function: Sets the transceiver’s circuitry for the CAT baud rate to be used.
Available Values: 4800bps/9600bps/38400bps
Default: 4800bps
MENU MODE No
x
020 [CAT/LIN/TUN]
Function: Selects the device which is connected to the CAT/LINEAR jack on the rear panel.
Available Values: CAT/LINEAR/TUNER
Default: CAT
MENU MODE No
x
021 [CLAR DIAL SEL]
Function: Defines the “control” knob to be used for setting of the clarifier offset frequency.
Available Values: CLAR, M/V, MAIN (Clarifier/Selector/Main Dial Knobs)
Default: CLAR
MENU MODE No-022 [CW AUTO MODE]
Function: Selects whether the KEY jack shall be “Enabled” or “Disabled” while using the SSB/FM modes.
Available Values: ON/OFF
Default: OFF
OFF:
The KEY jack is enabled on the CW mode only.
ON:
The KEY jack is enabled on all modes (SSB mode: A1, FM mode: F2). Thus, on SSB, you can ask a station for
a CW QSO without having to change your FT-857’s Mode selection, if Menu #022 is set to “On.”
MENU MODE No
x
023 [CW BFO]
Function: Sets the CW carrier oscillator injection side on the CW mode.
Available Values: USB/LSB/AUTO