FCC ID: K66FT-857
Operating Manual
Vertex Standard Co., Ltd.
62
020
CAT/LIN/TUN
Selects the device which is connected to the CAT/LINEAR
jack on the rear panel.
CAT/LINEAR/
TUNER
CAT
021
CLAR DIAL SEL
Defines the “control” knob to be used for setting of the
clarifier offset frequency.
CLAR, M/V, MAIN
CLAR
022
CW AUTO
MODE
Selects whether the KEY jack shall be “Enabled” or
“Disabled” while using the SSB/FM modes.
ON/OFF
OFF
023
CW BFO
Sets the CW carrier oscillator injection side on the CW mode.
USB/LSB/AUTO
USB
024
CW DELAY
Sets the receiver recovery time during pseudo-VOX CW
semi-break-in operation.
FULL/
30 ~ 3000 msec
250 msec
025
CW KEY REV
Sets the keyer paddle’s wiring configuration.
NORMAL/
REVERSE
NORMAL
026
CW
PADDLE
Enables/disables CW keying by the microphone’s
[UP]/[DWN] keys.
ELEKEY/MICKEY
ELEKEY
027
CW PITCH
Setting of the pitch of the CW sidetone, BFO offset, and CW
filter center frequencies.
400 ~ 800 Hz
700 Hz
028
CW QSK
Selects the time delay between when the PTT is keyed and the
carrier is transmitted during QSK operation when using the
internal keyer.
10/15/20/25/30 ms
10 ms
029
CW SIDE TONE
Setting of the CW sidetone volume level.
0 ~ 100
550
030
CW SPEED
Sets the sending speed for the built-in Electronic keyer.
4 ~ 60 wpm
(1wpm/step)/
20 ~ 300 cpm
(5cpm/step)
12
wpm(60
cpm)
031
CW TRAINING
Sends random Morse Code five-character groups via the
sidetone.
N, A, AN
N
032
CW WEIGHT
Sets the Dot:Dash ratio for the built-in electronic keyer.
1:2.5 ~ 1:4.5
1:3.0
033
DCS CODE
Setting of the DCS code.
104 Standard DCS
codes
023
034
DCS INV
Selects “Normal” or “Inverted” DCS coding.
Tn-Rn/Tn-Riv/
Tiv-Rn/Tiv-Riv
Tn-Rn
035
DIAL STEP
Setting of the DIAL knob’s tuning speed.
FINE/COARSE
FINE
036
DIG DISP
Defines the displayed frequency offset during DIG (USER-L
or USER-U) mode operation.
–3000 ~ +3000 Hz
0 Hz