EVX-S24 O
PERATING
M
ANUAL
5
W
ARNING
! IC RSS G
ENERAL
R
EQUIREMENT
E
NGLISH
This device complies with Industry Canada’s license-exempt RSSs. Operation. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
This radio transmitter (identify the device by certifi cation number, or model number if Category II) has been approved
by Industry Canada to operate with the antenna types listed at the right
with the maximum permissible gain and required antenna impedance
for each antenna type indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are
strictly prohibited for use with this device.
When transmitting, hold the radio in a vertical position with its microphone 1 inch (2.5 cm) away from your
mouth and keep the antenna at least 1 inch (2.5 cm) away from your head.
The radio must be used with a maximum operating duty cycle not exceeding 50%, in typical Push-to-Talk con-
fi gurations.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than 50% of
the time can cause IC RSS General Requirement to be exceeded. The radio is transmitting when the red LED on
the top of the radio is illuminated.
Body Worn Operation: When worn on the body, always place the radio in a Vertex Standard approved clip, hold-
er, holster, case, or body harness for this product. Using approved body-worn accessories is important because
the use of non-Vertex Standard approved accessories may result in exposure levels, which exceed the occupation-
al/controlled environment RF exposure limits.
A
PPROVED
A
NTENNA
ATU-6A:
−
2.15 dBi, 50-ohm ATU-20AS:
−
2.15 dBi, 50-ohm
ATU-6B:
−
2.15 dBi, 50-ohm ATU-20CS:
−
2.15 dBi, 50-ohm
ATU-6C:
−
2.15 dBi, 50-ohm ATU-20DS:
−
2.15 dBi, 50-ohm
ATU-6D:
−
2.15 dBi, 50-ohm ATU-20FS:
−
2.15 dBi, 50-ohm