12
Versa Lift
Installation - Assembly
(All
Models)
2a. LIFT HEAD ASSEMBLY - Using the
Rope Handles
provided, move the Lift Head into the attic for assembly.
Warning!
Heavy!! This job requires two able persons.
(After the lift head is in the attic, untie the rope handles
and save them.)
Locate the other parts shown below and
move them up to the attic for assembly to the Lift Head.
2b. INSTALL THE HOUSING LEGS
Assemble the four lift housing legs into the lift housing as
shown.
The locknuts will not work loose, so don’t over
-
tighten or you will collapse the square tubing. Note: The
DO NOT RUN the Lift
legs must fit to the INSIDE of the lift housing (see inset).
2c. INSTALL THE MOUNTING RAILS
Assemble the mounting rails onto the lift housing legs,
as shown, but do not tighten them yet. Leave them slight-
ly loose for leveling adjustment Step 4.
2d. INSTALL NYLON GUIDE SPACERS
Install two nylon spacers with a
2½”
screw and locknut to
the mounting rails in four places (by each leg) as shown
below. Tighten them snug, but do not over-tighten.
1/4-20 TALL LOCKNUT (4)
motor until this manual tells you to!
THE LIFT WILL MALFUNCTION IF YOU DO!
½ x 1” NYLON
SPACER (8)
(2 x 4 Places)
2c. INSTALL THE
MOUNTING RAILS
1/4-20 x1-1/2"
TRUSS SCREW (8)
MOUNTING
RAILS (2)
1/4-20 x 2-
1/2”
PHILLIPS PAN
HEAD (4)
2d. INSTALL NYLON
GUIDE SPACERS
Hardware Needed:
þ
1/4-20 x 1-
1/2”
Truss Screws (16)
þ
1/4-20 x 2-
1/2” Phil.
Pan-head Screws (4)
þ
1/4-20 Tall
Locknuts (20)
þ
½ x
1” Nylon
1/4-20 TALL
LOCKNUT (8)
Spacers (8)
LIFT HOUSING LEGS (4)
LIFT HEAD ASSY
LIFT HOUSING LEGS (4)
2b. INSTALL THE
HOUSING LEGS
1/4-20 TALL
LOCKNUT (8)
Fig. 22
Note: The legs fit
to the INSIDE of
the lift housing!
1/4-20 x 1-1/2"
TRUSS SCREW (8)
LIFT
HOUSING
!
CAUTION
!
