versa climber CL-108H, Руководство по эксплуатации

Страница: 19 / 54

10. Your calorie burn rate is displayed in the upper middle digits. This rate is dependent
upon weight entered and the rate at which you are climbing. (For CL-108HP models
only, the middle upper “CALORIE BURN RATE” readout has been replaced with
HEART RATE”) It is based on per hour figures and will display from 1 to 999 calories
burned. For calorie burn rates over a 1,000 only the last three digits will be displayed.
For example, if you are burning 1,123 calories per hour, your calorie burn rate will be
displayed as 123.
11. To display total calories (optional), press “ DISPLAY TOTAL CALORIES ” located in
the lower left of the display. The computer will ask you to “ ENTER WEIGHT ” in
pounds. By pressing the large numbers on the key pad, your weight in the range of 70-
350 lbs can be entered into the computer. Press “ ENTER ” If the weight entered is to
low, or too high, the computer will tone four times and the display will read “ value too
low ” or “ value too high ”. To obtain the total number of calories burned while you are
working out, press “ DISPLAY TOTAL CALORIES ” again. Total calories, up to 999, will
be momentarily displayed on the bottom of the display. The total calories burned will be
displayed for 2 seconds and then revert to the previous values displayed.
12. To get an average of your stroke length and feet per minute press “ DISPLAY AVER-
AGES ”. A tone will sound as these values are flashed in the lower window of the dis-
play. “ DISPLAY AVERAGES ” may be viewed in any mode and will appear for 2 sec-
onds and then return to the previous values displayed.
13. TO CHANGE MODES DURING A WORKOUT YOU MUST FIRST STOP CLIMBING
OR STEPPING FOR A FEW SECONDS. Then select another mode and enter the
appropriate data.
14 . If you should forget to turn the machine off or if input information to the computer is
interrupted for two minutes, one tone will sound and the computer will automatically
shut off. All data will be cleared from display.
15. If proper “key in” sequence causes the computer to “lock” or “freeze” and data can-
not be entered or changed, remove the battery from the back of the module momentar-
ily. Put the battery back into the module and continue.
NNOOTTEE ::
If you should make an error while entering data, press “clear” and the
last numbers entered into the system will be erased. Re-Enter correct data and
continue.
DO NOT OVER EXERT YOURSELF! IMMEDIATELY DISCONTINUE THIS
OR ANY OTHER EXERCISE IF YOU FEEL FAINT, DIZZY, SHORTNESS
OF BREATH OR ANY OTHER PHYSICAL DISCOMFORT.
Page 14