STEP 22:
Remove the ash drop assembly. Remove the hairpin cotter from the upper
end of the ash door clevis pin. Pull the ash door clevis pin down,
disengaging the hinge. Remove the ash door assembly. Remove the flat
ash grate. Turn the stove bottom over and remover, 4 each, ¼-20 x ¾”
hex head cap screws and 4 each, ¼” flat washers holding the ash drop to
the stove bottom. Gently tap and pry the ash drop loose.
STEP 23:
Remove the ash lip, 2 each, ¼-20 x ½” socket flat head machine screws.
Remover the 4 stove legs and handle holder, 4 each, 3/8”-16 x 1¼” hex
head bolts and 4 each, 3/8” flat washers.
STEP 24:
Remove the primary air manifold from the stove front, 1 each, ¼-20 x 2”
hex head cap screw at the centre of the manifold. Chip cement at the
joints with a cold chisel and ball peen hammer. Pry the manifold loose
with a pinch bar. Remove the andirons, 1 each, ¼-20 x ½” hex head cap
screw and 1 each, ¼” flat washer per andiron.
STEP 25:
Remove the two piece half hinge from the ash drop, 3 each, ¼-20 x ¾”
hex head cap screws and 3 each, ¼” flat washers. Take the split half hinge
apart, 2 each, ¼-20 x ¾” hex head cap screws and 2 each, ¼” flat washers.
STEP 26:
Remove the ash pan bracket from the ash door, 2 each, ¼-20 x ½” hex
head cap screws and 2 each, ¼” flat washers. Remove the handle from the
ash door, 1 each, 3/8”-16 hex toplock jam nut on the pawl. Loosen the ¼-
20x ¼” socket set screws on the pawl. Remove the pawl and pull the
handle out.
STEP 27:
Remove the damper from the upper fireback, 3 each, ¼-20 x ½” hex head
cap screws and 3 each, flat damper tabs. Lift out the damper. Remove the
torsion bar, 1 each, ¼-20 x ½” hex head cap screws and 1 each, torsion bar
clip. Pull the torsion bar from the upper fireback.
STEP 28:
Remove the primary air valve from the primary air frame. Pry the air rod
clip from the end of the rod. Push the air rod through its drillings and
remove the valve and rod from the frame.
