STEP 41 Cont: and when turned counter clockwise against its stop, should pull both doors
snugly against the stove front and each other.
If the doors are loose when the handle tab is fully engaged, open the right
door and turn the door handle 360 degrees (one full turn)
counterclockwise. Close the door and attempt to latch. If the tab will not
enter its opening in the stove front, remove the handle from the door and
either file or grind the handle face of the tab at an angle (see Fig.A-11) a
little at a time until a tight latch is obtained.
If, when latched, the door handle is not in the vertical position, remove
and replace the split roll pin (3/16”x1”) in the handle tab opening of the
stove front. After leveling and plumbing the doors and adjusting the
latching mechanism, check the seal of both doors by applying the
“notepaper test” (see Fig.A-12). If the doors fail the test, re-adjust the
hinge bosses, latch the doors and re-test.
Fig. A-11
Door Handle
W/Tab Before Grinding
Fig. A-11
Door Handle
W/Tab After Grinding
