RFS INSTALLATION INSTRUCTIONS
VERIZON HYBRIFLEX CABLE| Revision 1 | APRIL 2019
Visit
for the most current product specifications
Page 20 of 33
The following instructions are designed for use with the 5/8 and 7/8” HYBRIFLEX cable.
Note
, This is not a combo tool, size must be purchased as either 5/8” or 7/8”, also the cutting tool is a special
design; an ‘off the shelf’ pipe cutter from a local hardware store should not be used.
Note: Do not unscrew the roller guide.
To use the HTPT’s cutting tool to cut the outer
armor,
1) Using the jacket striping tool remove the jacket
off the cutting section
2) Hold the tool body and turn the handle counter
clockwise and adjust it to fit the 5/8 or 7/8” cable
(Figure 2)
3) Grasp the handle and body of the tool together
with one hand as shown in (Figure 2a) if, holding
handle only the body of the tool will spin.
4) While holding the tool body and handle with one
hand as shown on (Figure 2), insert the cable, as you
grasp the tool body and cable together with the
other hand as shown (Figure 3)
5) Turn handle clockwise until the blade engage the
cable jacket. Note: Ensure that the blade is seated
properly on the high end of the corrugation.
6) Slowly spin the tool around the cable tight handle
as needed. Continue until both jacket and armor is
cut through. As shown in Figure:
Hybriflex™ Jacket removal tool instruction
