RFS INSTALLATION INSTRUCTIONS
VERIZON HYBRIFLEX CABLE| Revision 1 | APRIL 2019
Visit
for the most current product specifications
Page 18 of 33
the installation. If this process is not easy enough or not acceptable, a clamp (e.g. RSB-Clip) may be placed on
the mark. This clamp will then stop the movement of the tool in the final position [see pictures 2-4].
Put the body of the grounding kit very carefully around the cable, in order to prevent damaging the outer
conductor, and then carefully tighten the nuts.
Finally use the supplied sealing materials as described in the grounding kits installation instruction to perform
a proper sealing of the complete kit.
Place the remaining third 50 mm (2”) piece of butyl mastic carefully over the
ground wire. (as shown in Diagram 5)
We recommend bending it with overlapping on both sides when placing over
the ground wire. Afterwards mold it in a straight line to the coaxial cable to
avoid holes where water could enter [see Diagram 5].
Special care must also be taken to form tile-like overlaps when wrapping the tape layers, i.e. start from the
bottom and end at the top.
