S
ETUP
Using the Reader
UX 410 I
NSTALLATION
G
UIDE
19
If you have questions about which power supply to use, contact your Verifone
representative. For more information, see
Attach and route all cables between the UX 410 and all peripheral units before
connecting to the power source.
Power Connections
The UX 410 connects to external power using a power pack (PWR159-00X-01-A
or the CPS12490-4A-R) connected to the power port on the Controller Unit.
To connect to a power
source
Connect the power cable to the power port on the UX 410 Controller Unit and the
other end to your power source.
Figure 11
Connecting Power Supply to the UX 410
For more information regarding your UX 410 Reader and Controller Unit
configuration, contact your local Verifone service provider. For cable ordering
information, see
Using the
Reader
The contactless reader is only active when signaled by an application for the start
of a contactless card transaction.
When the UX 410 antenna unit is ready to accept a transaction, the CTLS logo
and first LED from the left will light up.
CAUTION
Using an incorrectly rated power supply can damage the unit or cause it to
malfunction.
Verifone recommends the PWR159-00X-01-A or CPS12490-4A-R power packs.
See
for power supply information.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, Verifone recommends installing a power surge protector.
