S
ETUP
Connecting Cables
UX 410 I
NSTALLATION
G
UIDE
17
4
Carefully slide the SAM card into the slot, by aligning the card and carefully
sliding into the slot until fully inserted.
Figure 9
Inserting SAM Card
5
Close the SAM cardholder.
Connecting
Cables
The UX 410 Controller Unit rear panel holds several interface ports for power and
communications. Use this section to see how the Controller Unit connects to the
Antenna Unit.
Connecting to Host
Devices
This section discusses the cable requirements for connecting the Controller Unit
with the following host units:
•
Connecting to a Vending Machine
•
Connecting to a PC
Connecting to a
Vending Machine
You can connect the Controller Unit to a host vending machine (VM) with any of
the following connection types:
•
USB Type B
•
ETH (LAN)
NOTE
Before inserting the SAM card, position it as shown in
, with the card’s
gold contacts facing inward.
The SAM card has a notch on one corner to ensure that it fits into the connector
base in only one way.
NOTE
To get the correct connection cables, please refer to Accessories and
Documentation.
