S
ETUP
Mounting the Controller Unit
14
UX 410 I
NSTALLATION
G
UIDE
3
Slot the bolts through the installation panel and on through to the EVA
clamping plate (VPN PPL159-417-01-A).
4
Secure the unit with M4 washers and nuts. Tighten the nuts using the
recommended tightening torque of 5.0 kgf cm (0.49 Nm or 4.3 lbf in).
5
Remove the clear protective screen from the front of the unit.
Mounting the
Controller Unit
This section shows how to attach the Controller Unit to the installation panel for
stability and security.
Use the following steps to install the Controller Unit:
Figure 6
Mounting the Controller Unit
1
Align the Controller Unit mounting holes to the installation panel holes.
2
Insert four bolts and tighten the nuts using a recommended tightening torque
of 5.0 kgf cm (0.49 Nm or 4.3 lbf in).
CAUTION
Avoid placing metallic objects at the front and around the card reader.
CAUTION
•
For non-metallic variants (M159-410-0xx-xxx), the installation panel needs to
be plastic material.
•
For metallic variants (M159-410-1xx-xxx), the installation panel needs to be
metallic, and its size has to be at least 1 cm more. Do not start a contactless
transaction before a metallic UX 410 variant is installed correctly on a metallic
panel.
