7
Operation and maintenance, Discfilter HSF2600 - 2,3 series with PFLC
the equipment with a warning symbol is replaced, a new symbol must be attached in the same
position. Damaged symbols and CE markings must be replaced immediately.
2.4 Demands on personnel
Only personnel trained for the equipment and conversant with local regulations may perform
service and maintenance, in order to avoid personal injury and damage to the equipment. Ser-
vice and maintenance personnel may only handle those parts of the equipment they have been
trained for.
The operator may need to work inside the safety barrier and in the safety zone during mainte-
nance and set-up before operation.
2.5 Emergency stop
The filter is equipped with an emergency stop and a main switch,
see Figure 2.3.
In the event of a power outage, turn the main switch to the OFF
position (0) to prevent the filter drum from unintentionally star-
ting when the power returns.
2.6 Electrical safety
Electrical installation must be carried out by a qualified electrici-
an and in accordance with local regulations. Also see Appendix A
in the “Automation manual”.
The filter frame must be connected to earth, see section 6.4 in the “Handling” & Installation
Manual”.
The main power switch/emergency switch must be fitted in accordance with applicable regula-
tions.
2.7 Safety instructions
The filter is activated by turning the main power switch to the ON position (1), then selecting
AUTO, REMOTE or HAND mode using the mode selector located on the front of the electrical
cabinet.
NOTE! See instructions in section 4.1.
Turn the main power switch to the OFF (0) position and lock it with a padlock before per-
forming any work on the filter.
Access to the filter by unauthorized persons is strictly prohibited. Outdoor installations
Figur 2.3 Elskåp
A. Driftlägesomkopplare
B. Huvudbrytare
C. Nödstopp
