33
Operation and maintenance, Discfilter HSF2600 - 2,3 series with PFLC
6.8.2 Adjusting drive chain tension
Adjust drive chain tension as follows:
1. Turn the main power switch to the OFF (0) position and lock with a padlock.
2. Loosen the four nuts (A). See Figure 6.30.
3. Loosen the nut (B).
4. Adjust the tension of the chain using the
screw (C).
5. Secure the screw (C) using the nut (B).
6. Tighten the four nuts (A).
7. Close the filter cover
8. Start operation again as set out in section 4.1.
When the drive chain cannot be adjusted any more, the chain is worn and must be replaced, see
section 6.8.3.
6.8.3 Replacing the drive chain
1. Turn the main power switch to the OFF (0) position and lock with a padlock.
2. Lower the drive unit to its lowest position, see section 6.8.2.
3. Split and remove the drive chain. The drive chain can be separated in all links.
4. Fit the new drive chain.
5. Adjust drive chain tension in accordance with section 6.8.2.
6. Start operation again as in section 4.1 (Check procedures during start-up).
Figure 6.30 Engine suspension plate.
