34
Operation and maintenance, Discfilter HSF2600 - 2,3 series with PFLC
6.9 Drive unit
NOTE! Prior to servicing, read section 2.7.
For information about the drive unit, see Appendix D.
When changing the drive unit oil, the oil should pre-
ferably be drained with pump.
6.10 Inlet seal
NOTE! Prior to servicing, read section 2.7.
6.10.1 Checking inlet seal.
1. Turn the main power switch to the OFF (0) position
and lock with a padlock.
2. Lower the water level in the filter until the whole inlet gasket is accessible.
3. Check the inlet seal for damage and wear, see Figure 6.31.
4. If necessary, replace the inlet seal in accordance with section 6.10.2.
5. Start operation again as set out in section 4.1.
6.10.2 Replacing the inlet seal
1. Turn the main power switch to the OFF (0)
position and lock with a padlock.
2. Lower the water level in the filter until the
whole inlet gasket is accessible.
3. Note how the inlet gasket is fitted before it
is dismantled.
4. Loosen the screws and nuts holding the inlet
gasket in position.
5. Remove the inlet gasket.
6. Fit a new inlet seal.
7. Start operations again as set out in section 4.1.
Figure 6.32 Drive unit drained with pump.
Figure 6.31 Check of inlet seal.
