www.venuelightingeffects.com
7
Mounting orientation
The lightweight ThinPar 64 may be mounted in any position.
rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical Specifications” section of this
manual for a detailed weight listing. Mount the fixture securely. This may be done with a screw, nut and bolt, or a hanging
clamp (not included). The hole in each bracket can fit a 13mm screw or bolt. When rigging, consider routine maintenance
and back panel access. Please see the following steps for installation.
•
If the power link out is intended to be used with multiple fixtures, take into account the length of each power
cable, and mount the fixtures close enough to one another to account for this.
•
When aiming the fixtures, you may use the bracket angle knob. Loosen the knob, adjust to the desired angle,
and then tighten the knob by turning clockwise. Do not use tools for this step, as it may cause damage.
•
There is a secondary bracket, which may be used primarily for floor standing positions.
•
Safety cables must always be used.
BRACKET ANGLE KNOB
Note: Do not use a tool on
the bracket angle knob.
Tighten or loosen by hand.
MOUNTING BRACKET
SECONDARY BRACKET
(use primarily for floor standing position)
