thinpar 64 users Manual
6
4. SETUP
ac poWer
This fixture runs on 10.0.~240. VAC, 50./60. Hz. Before powering on the unit, make sure the line voltage is within the
range of accepted voltages.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture
or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its average current draw under
normal conditions.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel is used only as a 0 to 100% switch.
Always connect the fixture to a circuit with a suitable electrical ground.
poWer linking
This fixture contains power linking via the outlet located on the back panel. Please see the diagram below for
further explanation.
The maximum quantity of fixtures that may be linked is 40 units @ 120V, 60 units @ 230V, 10A circuit max.
