EN
VTS reserves the right to implement changes without prior notice
User’s Manual
7
EN / PL / RU
– jump to language selection
Change password
– allows entering speci
fi
c password to
protect the controller from unintended access
v.2.1 20-04-12
– application identi
fi
er
VS-OPTIMA
– controller type identi
fi
er
Note!
All the menus are dynamically changed, as they depend
on the application settings and the password level
If the system did not start, check the F1 protection status
Correct device operation depends on the application settings. Choosing and setting
up the application should be done by quali
fi
ed service provider, according to
recommendations of Advanced Manual
HMI OPTIMA SETTINGS & CONNECTING TO THE CONTROLLER
Holding the [OK] button, the internal menu of the HMI can be
entered.
Choose device
– can be used for operation of single HMI
OPTIMA with multiple controllers.
▪
Only one device – used for 1:1 connection with single
controller at
fi
xed address “1” (recommended mode)
▪
Scan devices – searching through the bus to detect all
addresses occupied by several controllers
Communication period
– gap between updating information
with the controller.
▪
Low limit: 0.0s
▪
High limit: 10.0s
▪
Default: 0.5s (recommended)
Communication timeout
– limit for the response from the
controller. Check if using converters / repeaters on the
communication line.
▪
Low limit: 0.0s
▪
High limit: 5.0s
▪
Default: 0.5s (recommended)
Contrast / Minimal brightness / Maximal brightness
–
settings for the LCD appearance
Activity time
– time to switch to idle state if no button operation
is performed
After activity time
– de
fi
nes the HMI behavior after switching
to idle state
▪
Nothing – don’t change the screen
▪
Alarms menu – jump to alarms menu if any alarm is
reported
▪
Alarms/1
st
page – jump to alarms menu in case of the
alarm otherwise jump to main menu
Choose device
Communication period
0.5s
Communication timeout
0.5s
