VENGE VIAS, Руководство пользователя

Страница: 26 / 36

23
5. HANDLEBAR/STEM ASSEMBLY (mechanical shifting)
A. PREPARING FACEPLATE
The faceplate can be assembled either with a Garmin computer mount bracket (S169900005) (Fig.1), or with a
flush mount faceplate cap (Fig.2).
1
B
A
2
A
C
D
E
„
Fig.1: To install the Garmin mount bracket (Fig.2-C), unscrew the two screws on the inside of the faceplate (A),
then remove the faceplate cover (B).
„
Fig.2: Place the Garmin mount bracket (C) in the cavity on the front of the faceplate (A), then reinstall the two
screws. Torque to 25 in-lbf (2.8 Nm).
„
Fig.2: Place the Garmin mount (D) on the bracket, then install the mount using the standard bracket (E, Garmin
only). Torque to 25 in-lbf (2.8 Nm).
B. INSTALLING MECHANICAL SHIFT AND HYDRAULIC BRAKE HOUSINGS
If running reversed brakes (UK), the brake housings must cross so that the front brake housing
enters the brake guide on the non-drive-side, while the rear brake enters the guide on the
drive-side (See fig.1).
1
REVERSED BRAKES:
Left=rear brake
Right=front brake
BLUE: FD GREEN: RD
A B
C
„
Install the shift/brake levers at the desired position, then mark the location of the levers.
„
Fig.1: Rotate the levers down on the handlebar curves, then install a section of shift housing
A B
into each
side of the handlebar. Run the housings through the handlebar until they exit the slot at the stem clamp area.