VENGE VIAS, Руководство пользователя

Страница: 29 / 36

26
6
REAR DERAILLEUR
FRONT DERAILLEUR
REAR BRAKE
FRONT BRAKE
„
Reinstall the fork in the head tube according to the steps in Chapter 1, Section A. “DETERMINING FIT”, page
7 . Be careful not to move the compression ring, keep it properly seated in the upper headset bearing.
„
Fig.6: Route the front/rear brake housings through the spacer stack, then place the spacer stack on the steerer tube.
The spacers are keyed to align with the compression ring and the stem.
„
Fig.6: Route the brake housings up through the stem, then guide the shifter cables between the spacers and the
steerer tube, and into the their respective holes in the compression ring on each side of the brake housing.
„
Continue routing the cables into the compression ring until the cables exit the frame at the shift cable exit ports,
then place the stem on the steerer tube until the pin on top of the spacer stack engages with the stem.
„
Adjust the front and rear derailleurs according to the manufacturer’s instructions.
Mark the brake housings so that it’s clear which is the front and rear housing. If running reverse
brakes (UK), make sure the front housing goes to the drive-side lever.
Support the brake housings with your fingers to prevent the housings from kinking as they make
the bend into the stem and into the handlebar to the brake levers. If a housing gets kinked, it will
have to be replaced.
Use an Internal Cable Routing kit to connect to the brake housings and pull them through the
handlebar.