VENGE VIAS, Руководство пользователя

Страница: 31 / 36

28
NON-ViAS SETUP
Certain Venge ViAS Disc frames come equipped with down tube entry ports to run a traditional stem/handlebar
setup with standard internal cable routing.
Two different top caps are available to transition from the Venge frame to a standard stem. Choose the 10mm or
25mm top cap and combination of 5mm and/or 10mm spacers to achieve the desired stem position.
„
Maximum spacers allowed over the top caps: 2 x 10mm and 2 x 5mm (30mm total).
S172500006 S172500007 S172500008 S172500009 S172500010
SPARE PARTS
The spare parts listed below are either not referenced in other parts of the manual, or have been identified as
frequently needed.
PART # DESCRIPTION
S172500006 HDS MY17 VENGE NON-VIAS COMPRESSION RING - UNIVERSAL
S172500007 HDS MY17 VENGE NON-VIAS LIGHT SPACERS - CONE SPACER 10MM
S172500008 HDS MY17 VENGE NON-VIAS LIGHT SPACERS - CONE SPACER 25MM
S172500009 HDS MY17 VENGE NON-VIAS NYLON SPACER - SPACER 5MM
S172500010 HDS MY17 VENGE NON-VIAS NYLON SPACER - SPACER 5MM
S159900006 MSC MY15 TARMAC MY16 VENGE VIAS DROPOUT EXIT FRAME PLUG FOR DI2 WIRE
S159900007 MSC MY15-17 (TARMAC / VENGE / ROUBAIX) BLANK DOWNTUBE FRAME PLUG FOR DI2
S169900008 MSC MY16 VENGE VIAS REAR DER PLUG FOR MECHINICAL SHIFTING
S179900013 MSC MY17 ROUBAIX / VENGE VIAS 7.5MM ANGLED ICR GROMMET
BRAKE HOUSING ROUTING SETUP
„
Fig.1: Insert the wire into the down tube on the non-drive-side, next to the rear brake housing, until it exits at the
bottom bracket exit port. Insert a Di2 plug in the empty mechanical shift port hole.
„
Follow the routing steps at the BB for the rear brake housing and the derailleur / battery wires (Section 3, page 15).
„
Fig.3: Place a Di2 grommet over the wire exiting the dropout and insert the grommet in the dropout exit port.
1
RUBBER GROMMET
BRAKE HOUSING
2
RUBBER GROMMET
RUBBER GROMMET