Vendlet V5S Speed Adjust, Руководство пользователя

Страница: 21 / 27

PART 3 - Technical manual PART 3 - Technical manual
40 41
Final inspection checklist Yes No
Was the VENDLET mounted by a qualified technician?
Is the combined weight of the client, the VENDLET and any other equipment
on/in the bed below the max. load of the bed?
Have the side rail dimensioning requirements been met?
Are all actuator fittings mounted at the same height and at the same distance
from the bed frame?
Do both bars run freely up and down?
Do both bars slacken and pull in the sheet?
Does the timer activate when the button is pushed twice within 2 seconds?
Does the timer turn off after 90 seconds of idle time?
Is the control unit securely suspended?
Are all cables securely attached to the bed with cable ties and away from the
moving parts of the bed?
Are all loose cables off the floor and wrapped around the cable guides on the
control unit suspension plate?
Is the slide sheet fitted on top of the mattress and properly attached?
Is the turning sheet fitted in such a way that it turns properly on the bars?
Is the quick guide visible and located near the bed?
Is the VENDLET manual available?
Have the care givers been instructed on the use of the VENDLET and its
functions?
Has the VENDLET system been signed up for an annual service check?
Date:
Carried out by:
Client:
Date of next periodic check:
DISMOUNTING, STORAGE, AND REMOUNTING
Dismounting
The VENDLET may be dismounted and transferred to another bed.
1. Lower the VENDLET bars.
2. Disconnect the power cable from the outlet.
3. Then the VENDLET can be removed by the same procedure as described in the
mounting section on page 31-33, ie:
• Remove the two strips that hold the cables in place on all four actuators.
• Dismount the actuator.
• Strap the VENDLET together so that the side rail can not run up and down.
• Loosen the bolts in the mounting plates and turn aside to lift VENDLET off
the bed frame.
Storage
The VENDLET should be stored in a dry location.
Temperature: -10°C - +50° C
Relative air humidity: 20% - 90% @ 30° C. No condensation.
Atmospheric pressure: 700 – 1060 hPa.
Remounting
Follow the procedure described in this manual if remounting is required.
Before the mounting, you should check all VENDLET parts for damage and whether
the date of the annual service check has not been exceeded.