PART 3 - Technical manual
PART 3 - Technical manual
46
47
REPAIRS
Only a limited number of VENDLET system components need regular replacement.
On the next pages, we will explain the more general repairs. Please do not hesitate to
contact us or our consultants if you need assistance or guidance or to perform repairs
or troubleshooting.
All repairs must be carried out by a qualified technician.
Replacing the motor in a bar
1. Raise the bar and remove the turning sheet from the bar on which the motor is
to be replaced.
2. Disconnect the power cable from the mains outlet.
3. Disconnect the motor bar cable from the control unit and remove the bar from
one of the fittings (you can also choose to disconnect the bar in both ends).
4. Remove the Allen screw at the motor end of the bar and pull the motor out.
5. Unscrew the small pivot screw on the motor fitting and remove it.
6. Mount the motor fitting on the new motor and attach it using the pivot screw.
7. Place the motor inside the bar and attach it using the Allen screw you removed
earlier.
8. Mount the bar on the two actuator fittings and connect the cable to the control
unit. Remember the plastic fittings.
9. Reconnect the power cable to the mains outlet.
10. Reset the system by simultaneously pressing the two top buttons on the hand
control. You will hear a series of rhythmic beeps. Press and hold the buttons until
the beeping stops.
11. Check whether the bar is working properly.
Dismount the bar from the actuator fitting
Remove the Allen screw
Remove the pivot screw
Remove the motor bracket and motor
Change the motor
