Vendlet 6200000, Руководство пользователя

Страница: 35 / 40

PART 3 - Technical manual
35
MAINTENANCE/CHECK
Annual check
VENDLET Basic must be serviced by a person with relevant
training annually. This check will ensure that the safety issues
pertaining to VENDLET Basic are in compliance with the stand-
ard as well as a long service life. The annual check includes the
following:
Electrical parts
Control unit no.:
Check the control unit including cables, plugs and mounting fittings for
signs of damage.
Check whether the timer deactivates after 90 seconds of idle time.
Check whether the green diode is illuminated.
When using an extension cable, check whether the cable has the
necessary quadrant (1.0 mm
2
).
Battery no. (if fitted):
Check the battery for signs of damage or corrosion.
Check that the battery backup works.
Hand control no.:
Check the hand control, cables and mounting fixtures for signs of
damage.
Check the functioning of all buttons and whether the green diode is
illuminated when the system is active.
Check all plugs, cables, and relief cables.
Check the stop function.
Bars Red side Blue side
Check the motors for signs of
damage.
Check all cables, plugs, and relief
cables for signs of damage.
Check whether the bar can be
operated manually when the
motor is disconnected from the
control unit.
Check whether the motor has full
pulling power when you press the
/ and reduced pulling power
when you press the / by
stopping the bar with your hand.
Mechanical parts
Check for signs of damage, damaged plastic parts and crooked fittings
or brackets and missing parts.
Check the bars and support bars for dents/deformations.
Check whether the groove on the bar is in good shape and works
with the edge strip of the turning sheet.
Check that the nylon straps are intact, fitted correctly to the bed and
side rails.
Check that the motors run correct, without any strange noises.
Check if the wear rings in the bars need to be exchanged.
Sheets
Is the turning sheet in good condition?
Is the slide sheet in good condition?
Functional tests
Do all bolts match the parts list and are they evenly
tightened?
Does the mounting meet all side rail dimension requirements?
Check whether it is possible to raise and lower the bars freely.
Check whether the VENDLET Basic works as intended when the hand
control is activated.
Replacements of parts
Installation instructions for replacement of bar incl motor,
support bars, plastic sliders for support bars, control unit,
hand control, nylon straps and corner post can be provided on
request.
After any repairs or replacements all points of the “Checklist
for daily inspections” (page 22) must be controlled.