![background image](http://html1.mh-extra.com/html/velleman/camip7/camip7_user-manual_3952416014.webp)
CAMIP7
13.01.2011
©
Velleman nv
14
•
Fill out all FTP server data. The port is usually set to 21.
•
Set the FTP mode to standard (PORT) or passive (PASV).
•
When desired, check the ‘Upload Image Now’ checkbox and set an upload interval (in seconds).
•
Press ‘Submit’ to store the data before performing an ‘FTP test’. A successful test will display ‘FTP
test succeeded’. Possible error messages are:
•
Can not connect to server.
Check FTP server address
•
Network error. Please try later.
Check network cabling and settings.
•
Server error.
Check the FTP server
•
Incorrect user or password.
Make sure to enter the right user name and password.
•
Can not access the folder.
Make sure the folder exists and your FTP account is authorized.
•
Error in PASV mode.
Make sure the server supports PASV mode.
•
Error in PORT mode.
If the device is behind a NAT (Network Address Translation) device, PASV mode must
be selected.
•
Can not upload file.
Make sure your FTP account is authorized.
Alarm Service Settings
•
Check the ‘Motion Detect Armed’ checkbox to enable motion detection. This also allows mails to
be sent out (see
Mail Service Settings
) and image upload to an FTP server (see
FTP Service
Settings
).
Note:
when the camera is in auto tilt/auto pan mode (see
For Operator
layout), motion
detection and external alarm input are disabled!
•
The motion detect sensibility van be set between 1 and 10, with 10 being most sensitive.
•
Check the ‘Send Mail on alarm’ checkbox to send a mail when an alarm is detected. Make sure to
fill out all fields on the ‘Mail Service Settings’ page (see above).
Содержание CAMIP7
Страница 2: ...CAMIP7 13 01 2011 Velleman nv 2 Figure...