CAMIP5N
V. 02 – 22/05/2012
18
©Velleman nv
Log
The log shows an overview of everyone who accessed the IP camera. It is cleared when rebooting the system.
Back
Use this option to return to the
For Visitor
or
For Operator
page layout.
9.
Additional user information
9.1
Password
Default, the administrator login is
admin
without a password. To enhance security, a new administrator
password should be set as soon as possible (see
§8.5
under
For Administrator layout – Users Settings
).
If the login or password of the administrator(s) are forgotten or corrupt, the system can be reset to factory
defaults (
admin
, no password) by pressing and holding the
RESET
button at the bottom of the camera for
about 5 seconds.
9.2
WiFi
1.
Refer to the user manual of your wireless router to obtain network information e.g. SSID, Channel,
Security, authentication, encryption…
2.
Use previously obtained information to configure your
CAMIP5N
via a fixed network cable (
For
Administrator
– Wireless LAN settings).
3.
Reboot the
CAMIP5N
.
4.
Wait at least 30 seconds before unplugging the network cable. Then unplug the power supply.
5.
Re-insert the power plug.
After about 30 seconds, the camera should be up and running in WiFi mode.
9.3
Connect the camera on an ADSL network
1.
Connect the camera to a PC. The easiest way is to use a router. If nPo router is available, you must use a
cross cable (not incl.) to connect the
CAMIP5N
directly to the PC’s 8P8C (RJ45) port and set the IP
addresses on PC and camera manually.
2.
Configure the camera with the IP camera tool (see
§8.1
).
3.
Log on to the camera as administrator and configure
ADSL settings
(user name + password).
4.
Configure the
DDNS Service Settings
and click
Submit
. The camera reboots.
5.
Connect the camera directly to the ADSL modem. It is now available through the internet by entering the
domain name in your internet browser.
Note
: set the option
Report ADSL IP by mail
under
Mail Service Settings
to receive the camera’s IP
address by mail.
9.4
Connect the camera via a router
1.
Connect the camera to the LAN and configure the camera with the IP camera tool (see
§8.1
).
2.
Log on to the camera as administrator and configure
DDNS Service Settings
.
3.
Click
Submit
to reboot the camera.
The camera is now available through the internet by entering the domain name in your internet browser.