CAMIP5N
V. 02 – 22/05/2012
16
©Velleman nv
FTP Service Settings
Note
: these settings only take effect when the option
Upload Image on Alarm
is checked in the
Alarm
Service Settings
menu (see below).
•
Fill out all FTP server data. The port is usually set to 21.
•
Set the FTP mode to standard (PORT) or passive (PASV).
•
When desired, check the
Upload Image Now
checkbox and set an upload interval (in seconds).
•
Press
Submit
to store the data before performing an ‘FTP test’. A successful test will display
FTP test
succeeded
. Possible error messages are:
o
Cannot connect to server.
Check FTP server address
o
Network error. Please try later.
Check network cabling and settings.
o
Server error.
Check the FTP server
o
Incorrect user or password.
Make sure to enter the right user name and password.
o
Cannot access the folder.
Make sure the folder exists and your FTP account is authorized.
o
Error in PASV mode.
Make sure the server supports PASV mode.
o
Error in PORT mode.
If the device is behind a NAT (Network Address Translation) device, PASV mode must be selected.
o
Cannot upload file.
Make sure your FTP account is authorized.
Alarm Service Settings
•
Check the
Motion Detect Armed
checkbox to enable motion detection. This also allows mails to be sent
out (see
Mail Service Settings
) and image upload to an FTP server (see
FTP Service Settings
).
Note
: when the camera is in auto tilt/auto pan mode (see
For Operator layout
), motion detection and
external alarm input are disabled!
•
The motion detect sensibility can be set between 1 and 10, with 10 being most sensitive.