IG-305-EN version 01; 07/04/2020
12
Installation
General Instructions
Outdoor cubicles:
cgmcosmos
,
cgm
.3 and
cgm
.800 systems
4. Installation
4.1. Unpacking the equipment
It is advisable to cut the cellophane at the rear of the cubicle or at the corner to avoid scratching the surface.
The outdoor cubicles are supplied protected in plastic as
standard.
On receiving the equipment, check that the goods supplied
correspond to the order and associated documentation. If
this is not the case, contact
Ormazabal
immediately.
The disassembly process for the equipment is as follows:
1.
Use a blade, cutter or similar tool to cut the cellophane
the cubicle is wrapped in
[2]
.
2.
Completely remove the cellophane.
3.
Detach the white polystyrene corner pieces.
4.
Unscrew the fixings between the base and the pallet.
5.
Remove the pallet, handling the cubicle as indicated in
section 2.1.
6.
Dispose of any waste in an environmentally friendly
manner.
It is advisable to make a visual inspection of the equipment
to check whether it has suffered any damage in transit. If
damaged, contact
Ormazabal
immediately.
4.2. Fastening outdoor cubicles to the floor
To install outdoor cubicles with gas output to trench, follow
the procedure for fastening to the floor described in the
corresponding GI document.
Furthermore, we recommend sealing the outer perimeter
of the enclosure and bottom front cable compartment
access cover using a single-sided adhesive cellular foam
seal, 30 mm wide and 5 mm thick, made of EPDM material
(
Ormazabal
reference: 440142).
Содержание Ormazabal cgm.3
Страница 27: ......
