ISD Component Installation
Carbon Canister Vapor Polisher Installation
Carbon Canister Vapor Polisher Installation
1.
During the installation, all required National, State and local safety codes must be followed.
2.
A Transmitter /battery pack pair must be installed with the Veeder-Root Carbon Canister Vapor Polisher
(CCVP) in a weatherproof enclosure mounted on the vent stack (see Figure 15).
3.
Install the CCVP sensor following instructions accompanying the sensor.
4.
Using two #10 taptite screws from the kit, attach the Transmitter housing to the side of the L bracket from the
wireless installation kit - do not attach L bracket/transmitter assembly to the back mounting surface at this
time.
5.
Get the battery pack mounting bracket from the wireless installation kit and put the threaded connector fitting
of the battery housing through the large hole in the bracket.
6.
Get the thin hex nut from the kit and screw it onto the battery housing cable connector threaded fitting until
snug (see item 3 in Figure 16).
7.
Attach the battery housing/bracket assembly to the back mounting surface of the enclosure using two #10
taptite screws from the kit (see item 4 in Figure 16).
8.
Remove the cover of the transmitter. Connect the non-connector end of the cable that connects the CCVP to
the transmitter as described in the section below entitled “Connecting Sensor Cables To The Transmitter” on
page 24, then attach the transmitter/L bracket assembly to the back mounting surface using two #10 taptite
screws from the kit.
9.
Attach the connector end of the CCVP cable to the Carbon Canister’s Vapor Valve connector (see Figure 17).
10. Insert the battery pack into its support bracket - do not connect the battery cable to the battery pack at this
time.
19-21
ARB Approved IOM 19 - TLS RF Wireless 2 System (W2) Installation and Maintenance Guide - Executive Order VR-203 and VR-204
