background image

TLS Warnings And Alarms

1

TLS Warnings And Alarms

The TLS console is constantly monitoring its probes and sensors for warning and alarm conditions, such as fuel 
leaks, excessively high or low fuel levels, and equipment problems. In the Operating Mode with no warning or 
alarm condition active, the TLS-3XX consoles display ‘ALL FUNCTIONS NORMAL’ and the TLS4/8601 & 
TLS450PLUS/8600 consoles display ‘SYSTEM STATUS’. When a warning or alarm condition occurs, the system 
displays/posts the alarm type and its location, indicating either tank, input or sensor number. Consoles with 
printers generate an alarm report showing the warning or alarm type, the location and the date and time of the 
warning or alarm condition that occurred. TLS4/8601 & TLS450PLUS/8600 consoles can be programmed to 
email a selected address if warnings/alarms occur.

WARNINGS

 - These indicate that an alarm is imminent or that a system fault has occurred. 

ALARMS

 - Alarms indicate that a potentially dangerous situation may have occurred.

WARNING! DO NOT IGNORE ALARMS! Know the alarm response procedures for your site.

When a Warning or Alarm is posted follow the procedure below to acknowledge the alarm and shut off the audible 
beeper:

In-Tank Warning And Alarm Levels

TLS-3XX Consoles

TLS4/8601 & TLS-450PLUS/8600 Consoles w/Display

Press the front panel red 
ALARM/TEST key to 
silence the alarm. The 
front panel warning and 
alarm lights cannot be 
turned off until the cause 
of the condition is cor-
rected. The warning and 
alarm message(s) will 
remain active. If more 
than one alarm or warn-
ing exists the display will 
flash the messages alter-
nately until the cause of 
the alarm condition is cor-
rected.

Touch anywhere on the status/warning or status/alarm bar (shown) at the top of the touch screen 
to go to the Reports > Alarms > Active screen and view the cause of the alarm. While in that 
screen, touch the status bar again to acknowledge the warning/alarm and shut off the beeper. 
The warning and alarm message(s) remain on the active alarm report screen until the cause of 
the condition is corrected. The warning/alarm status bar will continue to display until the alarm 
condition is corrected.

TLS4/8601 & TLS-450PLUS/8600 Consoles w/o Display

Touch the red ALARM RESET button on the console’s front panel to acknowledge the warning/
alarm and shut off the beeper. Warnings and alarms will remain active until the cause of the 
condition is corrected.

ALARM

TEST

L 10: FUEL ALARM

0 Warning(s)

1 Alarms(s)

ALARM

RE

S

ET

Typical European Tank

SAFE WORKING CAPACITY
Maximum Product Alarm Level

Overfill Alarm Level

High Product Alarm Level

Fuel Draw
Off Level

Delivery Needed Warning Level

High Water Warning Level

Low Product Alarm Level

High Water Alarm Level

("Label" Volume)

Annular (Interstitial) Area

Full Volume

Interstitial Sensor/Header Tank

Содержание TLS-3 Series










Отзывы: