Veeder-Root Mag-FLEX, Руководство по установке

Страница: 19 / 31

Mag-FLEX Installation And Handling Procedure Mag-FLEX Probe Installation
15
Mag-FLEX Probe Installation
1.
Unpacking the probe
2. Removal of the packaging
The probe shipping box is 1.1m square
and12cm deep. The probe is coiled to a
diameter of approximately 1m. The probe
should not be unpacked until the tank is
ready to accept it. Where possible, the
probe should be transported to the top of
the tank in its packaging.
Two people are required to remove the
probe from its packaging to prevent any
kinking or distortion of the flexible probe
shaft.
Damage caused by mishan -
dling will not be covered
under warranty.
• If there is deformation at the transition
points between probe shaft and
corrugated sections extreme care must
be taken to straighten them before
installation in to the tank.
• Always keep the probe coils parallel. Do
not lift one coil separately from the
others. Never twist one coil 90º from the
others.
• Do not twist the probe during
installation. Always keep the coils of the
probe parallel. “Unroll” it progressively
into the tank.
• Do not let the coil become less than 1m
in diameter whilst uncoiling.
NOTICE
1m