Using your machine
Using your machine
Using the hose and SpinScrub tool
CAUTION:
Test for colourfastness - Wet a white absorbent cloth with the solution. In a small hidden area of your carpet/
rugs/upholstery gently rub with the dampened cloth. Wait ten minutes and check for colour removal or bleed with a white
paper towel or cloth. If your carpet has more than one colour, check all colours.
Pour required amount of
carpet cleaning solution
into the clean water/
solution tank.
Press trigger on hose to
release solution/water.
Push hose end and
hose solution connector
into hose and solution
connection port.
Fill the clean water/
solution tank with warm
water (max 40’C).
Squeeze trigger on the
forward stroke, release
trigger on backward
stroke to recover
solution/water.
Slide SpinScrub tool over tab at end of hose until it
clicks into place.
Pull down accessory hose
connector cover.
Turn wash/rinse dial
to ‘wash’.
Plug into mains,
press the On/Off button
to switch on.
TIP
Use the carpet washer or hose to
pick up spills before washing and
cleaning the area.
Emptying the dirty water tank
CAUTION:
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Press dirty water tank
release latch, pull to
remove dirty water tank.
To re-fit, tilt dirty water tank and line
up onto carpet washer. Push back
until it clicks into place.
Pull and lift dirty water
tank clip to release lid.
Lift to remove dirty water
tank lid.
Empty dirty water over
the sink. Rinse dirty water
tank and lid under water
to remove dirt/ debris.
Clean the filter screen
located at the back of the
dirty water tank.
Empty and rinse out clean and
dirty water tanks and leave to
air dry before replacing.
Do not leave solution stored in
the tanks between uses.
IMPORTANT
Washing hard floors
CAUTION:
To prevent damage to wood floors and other hard floors, follow the flooring manufacturer’s
cleaning recommendations. Inspect floor surface for worn, finish, bare wood or separated joints.
If it’s not recommended to use the carpet washer on floors if any of these conditions exist.
IMPORTANT:
Before attaching the hard floor squeegee onto carpet washer, remove tanks or make sure tanks are empty
before lying the carpet washer on its back.
Lie carpet washer on its back, line
up squeegee with nozzle.
Hook front of squeegee onto edge
of nozzle.
Push squeegee under nozzle until it
clicks into place.
Click