Using your machine
Using your machine
NOTE:
The carpet washer should be in the upright position when using the hose or pre-treatment wand; de-activating the
SpinScrub brushes and brushbar.
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Using the pre-treatment wand
Pour required amount
of carpet/pre-treatment
cleaning solution into tank.
Tighten cap before
returning tank to unit.
Fill the clean water tank
with warm water
(max 40’C).
Turn wash/rinse dial
to ‘wash’.
Pull down accessory hose
connector cover.
Push wand connector into
solution tube port.
Plug into mains,
press the On/Off button
to switch on.
Press and hold trigger
on pre-treatment wand,
spraying evenly over
stubborn stains.
15
Leave the solution for
10-15 minutes before
washing carpet.
Using the upholstery wash tool
NOTE:
The carpet washer should be in the upright position when using the upholstery tool; de-activating the SpinScrub
brushes and brushbar.
Pour required amount
of carpet/pre-treatment
cleaning solution into
tank. Tighten cap before
returning tank to unit.
Push hose end and hose
connector into hose and
solution connection port.
Fill the clean water tank
with warm water
(max 40’C).
Pull down accessory hose
connector cover.
Turn wash/rinse dial
to ‘wash’.
Plug into mains,
press the On/Off button
to switch on.
Slide upholstery tool over tab at end of hose until it
clicks into place.