Using your machine
TIP
TIP
This machine has an Auto mix tank
so any solution not used can be
poured back into the bottle.
For best cleaning results use
slow
straight parallel strokes.
Intermittent dry forward
strokes will increase water
pick up.
Filling the water/solution tank
Using your machine
CAUTION:
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
NOTE:
Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary to repeat
the cleaning process. Make crisscrossing strokes to the original pattern and overlap each pass.
IMPORTANT:
Your dirty water tank is fitted with a float. When the dirty water tank is full, or the floorhead is not in contact
with the carpet the float will shut off the suction on the carpet washer. You will be able to hear if this has happened as the
motor noise on the machine will increase. Once the float is activated, empty the dirty water tank if full. If the dirty water tank
is not full then turn off your machine at the power switch and wait for the float to settle.
Press clean water/
solution tank release
button, pull and lift to
remove tank.
Pour required amount of
carpet cleaning solution
into the clean water/
solution tank.
Press the recline
pedal and pull
handle backwards.
Tilt clean water/solution
tank and line up onto
carpet washer. Push tank
back until it clicks into
place.
Twist solution tank
cap anti-clockwise
and remove.
Turn wash/rinse dial to
‘wash’. The SpinScrub
brushes and brushbar
deep clean your carpets
with water and solution
removing dirt and stains.
Fill the clean water tank
with warm water
(max 40’C).
Fill the clean water/
solution tank with warm
water (max 40’C).
Squeeze the trigger to
release solution and
water mix.
Pour required amount of
carpet cleaning solution
into tank. Tighten cap
before returning tank
to unit.
Turn wash/rinse dial to
‘wash’. The SpinScrub
brushes and brushbar
deep clean your carpets
with water and solution
removing dirt and stains.
For best results apply
water/solution on the
forward stroke and
release the trigger to pick
up water/solution on the
backward stroke.
Plug into mains,
press the On/Off button
to switch on.
Plug into mains,
press the On/Off button
to switch on.
Turn wash/rinse dial
to ‘rinse’. Only water
is released to remove
solution residue.
Press the boost trigger to
remove tough stains.
