coffee/steam button “ ”
is at the higher position, the pump will pump water, when there is
water flowing out, close the pump immediately.
5. Press down the coffee/steam button“ ” to the lower position and wait for a moment, the
appliance begins to heat until the (green) lamp illuminates, it means the heating is finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam
wand about 2 centimeters into the milk. Turn the steam knob in anti-clockwise slowly to start
making steam.
7. Then the desired result is got, you can turn the steam knob to the “O” position.
8. Please follow the operation as below to avoid the steam outlet being blocked after finish
frothing milk each time: put an empty jug under the steam band, then turn on the steam knob
and press down the pump control button “
” to the lower position, the pump will pump
water, after the water flowing out for 30 seconds, press the pump control button “
” to the
higher position, finally, clean the steam outlet with wet sponge, but care not to be burnt!
9. Press and release the ON/OFF button “ ”
to cut off the power source.
Note
: Please follow the operation as below if the steam outlet is blocked: firstly turn the
steam knob to “O” position and make the coffee maker cool down for about half an hour,
then poke the steam outlet for several times with a needle about 1mm in diameter, finally,
press down the coffee/steam button “ ” and turn on the steam knob to check if the appliance
can produce steam normally when the steam indicator (green) illuminates. Please contact the
service department if the appliance can not produce steam after operate as above.
Note
: after steaming, we recommend you allow the maker to cool down at least for 5 min
