g
ene
ra
l
3
Värmebaronen EK 15E
Read these instructions carefully before installation
and operation!
Keep these instructions at the electric flow heater!
Check that the electric flow heater has not been
damaged during transport. Report any transport
damage to the carrier.
Check that the delivery is complete.
All installation must be performed by an authorised
person in accordance with the existing regulations.
Never disable the safety equipment!
The electric flow heater must never be switched off
electrically unless the heating system is full and the
flow heater vented.
Correct installation in combination with correct
adjustment and continuous service will produce high
operational reliability and good heating economy.
The electric flow heater must not be modified, changed
or converted in any way.
Only authorised persons may carry out work on the
electric flow heater.
Ensure the power to the electric flow heater is switched
off before service / repair.
Never carry out maintenance work / service on
pressure-bearing parts when they are pressurised.
The electric flow heater may not be used by children
or people with physical or mental impairments.
Nor by children / people who lack knowledge about
the electric flow heater.
Children may not play with the electric flow heater
and connect accessories.
Always contact your installation engineer for service.
The type and manufacturer's number of the electric
flow heater must always be specified when contacting
Värmebaronen. See the rating plate
Värmebaronen AB reserves the right to change the
specification, in accordance with its policy of continuous
improvement and development, without prior notice.
The following icons are used in these instructions
to indicate important information:
Information that is important for optimum
operation.
Tells you what you should or should not do
to avoid personal injury.
Tells you what you should or should not do to
prevent a component, the electric flow heater,
a process or the environment from being
damaged or destroyed.
Electrical hazard!
Safety and handling
Function
Electric flow heater EK 15
Output 14.7 kW, divided into seven 2.1 kW stages, which are
controlled via an electronic temperature control, 20-95°C.
Can easily be climate controlled.
Load guard with current transformers included.
All-pole switch.
Operation / status indication.
Stainless electric flow heater.
Connection for external blocking connection or output
control 0-10V.
Output signal for external display of connected output.
Overheating protection with alarm indication.
A low water volume and well-insulated tank mean
low heat loss.
Brackets for wall mounting included.
Compact format.
Simple connection
Mounted on the wall with included brackets.
Has connection for front / safety line on top, return line
is on the bottom.
Temperature control
The temperature control regulates output connection in
seven stages.
Available accessories include an outdoor temperature sensor,
which allows the temperature of the electric flow heater to
be determined by the outdoor temperature and the selected
heat curve, UTK. A room unit is also available that, when
used with the UTK function, increases heating comfort at
the lowest possible energy consumption by utilising passive
heat from, e.g., solar radiation. The unit also reduces
variations in room temperature caused by wind.
The electronic controls contain an over temperature function,
which switches off selected output if the boiler temperature
exceeds the setpoint with an adjustable value. When the over
temperature ceases, the output is automatically reconnected.
When any of these functions take effect, the status indicator
blinks to indicate this.
Accessories
Outdoor temperature sensor
Room device.
