Variquest Trifecta 800, Руководство пользователя

Страница: 29 / 46

PAGE 29
Troubleshooting
Printer Issues
Prints do not stick to the bed despite using the
bed-leveling wizard. The bed-leveling wizard will serve as a good reference point to
which to level your bed. Depending on the accuracy of the calibra-
tion, you may need to make micro adjustments once the printer
begins a print.
As the printer begins a print and extrudes the outer skirt of the
model, check to see if the skirt is sticking firmly onto the blue tape.
If the filament seems bead-like, adjust the thumbscrew closest to
the affected area cclockwise to bring the distance of the print
surface closer to the nozzle.
Hard to remove the print from the print surface. For large prints, remove the bed clips securing the glass build
surface and place it down on the flat surface. Use a thin metal palette
knife and find a corner edge of the print to wedge the knife under.
Slowly repeat this process around accessible areas on the model.
Once the knife is mostly under the printed object, twist the knife and
use the leverage to pop the print object off the build surface.
X/Y/Z axis homes abruptly during printer or
printing stops before completion. The file being printed may be improperly combined or manifolded
within the modeling software. Correct within source software or use
a model repair software. Check for structural defects within the
slicing software by using the layer viewer after slicing.
Corrupted SD card. Reformat the SD card to FAT format and
re-save the GCode file onto the SD card.
ISSUE SOLUTION