ISTRUZIONI PER L’USO
4
87-900-884-01 (C)
MESSAGGI DI ERRORE
In alcuni casi di guasto la circuiteria di autodiagnosi del
controller presenta alcuni messaggi di errore elencati
nella tabella seguente.
NOTA
I messaggi di errore sono presentati solo se è installata
l'opzione "hand held terminal".
MESSAGGIO
DESCRIZIONE
AZIONE CORRETTIVA
CHECK CONNECTION TO
PUMP
Malfunzionamento nel collegamento tra
pompa e controller.
Verificare che il cavo di collegamento tra pompa
e controller sia ben fissato da entrambe le
estremità e non sia interrotto. Premere due volte
il pulsante START per riavviare la pompa.
PUMP WAITlNG INTERLOCK
È attivo il segnale di interlock presente sul
connettore P1 a causa dell'interruzione del
collegamento tra il pin 3 ed il pin 8 del
connettore J1, o a causa dell'apertura del
segnale di interlock esterno.
Ripristinare il collegamento tra il pin 3 ed il pin 8
del connettore J1, o chiudere il segnale di
interlock esterno.
FAULT: PUMP OVERTEMP.
La temperatura del cuscinetto superiore
della pompa ha superato i 60 °C.
Attendere che la temperatura ritorni al di sotto
della soglia. Premere due volte il pulsante
START per riavviare la pompa.
FAULT: CONTROLLER
OVERTEMPERATURE
La temperatura del trasformatore del
controller ha superato i 90 °C.
Attendere che la temperatura ritorni al di sotto
della soglia. Premere due volte il pulsante
START per riavviare la pompa.
FAULT: TOO HIGH LOAD
Durante il funzionamento normale (dopo la
fase di avvio) la corrente assorbita dalla
pompa è maggiore di quella programmata.
Verificare che il rotore della pompa abbia la
possibilità di ruotare liberamente. Premere due
volte il pulsante START per riavviare la pompa.
FAULT: SHORT CIRCUIT
Durante il funzionamento normale (dopo la
fase di avvio) la connessione di uscita è in
corto circuito (corrente di uscita maggiore di
12 A).
Verificare i collegamenti tra pompa e controller.
Premere due volte il pulsante START per
riavviare la pompa.
SYSTEM OVERRIDE
La pompa è stata fermata da un segnale di
emergenza proveniente da un contatto
remoto.
Staccare il cavo di alimentazione del controller e
rimuovere la causa dell'emergenza. Ricollegare
il cavo di alimentazione e premere due volte il
pulsante START per riavviare la pompa.
OVERVOLTAGE
Si è verificato un guasto nella sezione di
alimentazione del controller, o il controller
ha ricevuto un segnale spurio.
Premere due volte il pulsante START per
riavviare la pompa. Se il messaggio si
ripresenta rivolgersi alla Varian per la
manutenzione.