Vapotherm Oxygen Assist Module, Инструкция по эксплуатации

Страница: 26 / 32

Page 26 3101126 Rev A Vapotherm Oxygen Assist Module Instructions for Use
Appendix A
Electromagnetic Compatibility (EMC)
WARNINGS:
•
Portable RF communications equipment (including peripherals such as antenna cables
and external antennas) should be used no closer than 30 cm (12 inches) to any part of the
Precision Flow
®
with Oxygen Assist Module System, including cables specified by Vapotherm.
Otherwise, degradation of the performance of this equipment could result.
•
Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this equipment and the
other equipment should be observed to verify that they are operating normally.
•
Use of accessories, transducers and cables other than those specified or provided by the
manufacturer of this equipment could result in increased electromagnetic emissions or
decreased electromagnetic immunity of this equipment and result in improper operation.
•
Do not use any cables not provided by the manufacturer of this equipment.
Guidance and manufacturer’s declaration – electromagnetic emissions
The Oxygen Assist Module is intended for use in the electromagnetic environment specified below.
The customer or the user of the Oxygen Assist Module should assure that it is used in such an
environment.
Emissions test Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11
Group 1
The Oxygen Assist Module uses RF energy only for
its internal function. Therefore, its RF emissions are very
low and are not likely to cause any interference in nearby
electronic equipment
RF emissions
CISPR 11
Class A
The Oxygen Assist Module is suitable for use in all
establishments other than domestic, and may be used in
domestic establishments and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes, provided
the following warning is heeded:
Warning: This equipment/system is intended for use by
healthcare professionals only. This equipment/ system
may cause radio interference or may disrupt the operation
of nearby equipment. It may be necessary to take
mitigation measures, such as re-orienting or relocating
the Oxygen Assist Module or shielding the location.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Complies