Vaporless ISM-4080, Руководство по установке и эксплуатации

Страница: 10 / 24

10
2 ND M
ENU
:
All must complete 2
nd
Menu
The MENU button is used to enter specific information about the facility and how it is to operate. When
the MENU button is pushed, a Category will be displayed.
Push
MENU
–
RUN TIME SETUP
Push
ENTER
–
RESILIENCY VALUE
Then enter the Resiliency Value, up to 9999 ml
PRODUCT 1 ####
Push and hold the UP Arrow or the DOWN Arrow to
Write down the Line Resiliency Value here: increase or decrease the value. Read Line Resiliency
and Testing in the LDT-890 installation instructions
___________________ ml and read
Bleed-Back Measurement: Page 13.
If the Resiliency is non-zero, then the Repressure and Delay times will automatically be calculated. The
next two screens will allow you to view the calculated values. WRITE DOWN the REPRESSURE and
DELAY VALUES BELOW on this sheet. Do not change the values displayed below unless you have
consulted with VMI.
Push
ENTER
–
REPRESS TIME MIN
Use the UP and DOWN ARROWS to adjust the
PRODUCT 1 __._
value between 0 and 20 minutes.
Push
ENTER
–
DELAY TIME MIN
Use the UP and DOWN ARROWS to adjust the
PRODUCT 1 ___._
value between 0 and 150 minutes.
Pushing
ENTER
will cycle back through for subsequent Channels
After all Channels have been programmed:
Push
MENU
-
REPRESSURE
Used to program a time period when repress-
DISABLE TIME
urization is disabled for tank test quiet time. Only set
this up if the tank monitor is unable to complete a tank
test during normal operation quiet time.
Push
ENTER
–
DIS START HOUR
Use the UP and DOWN ARROWS to adjust the
PRODUCT 1 ##
disable start time hour (24 hour clock)
Push
ENTER
–
DIS END HOUR
Use the UP and DOWN ARROWS to adjust the
PRODUCT 1 ##
disable end time hour (24 hour clock)
Pushing
ENTER
will cycle back through subsequent Channels. After all Channels have been
programmed:
Push
MENU –
SUMP SENSOR
Sump Sensor Menu
SETUP