Vanderbilt
8
A6V10200077_e
Installation Instructions
08.02.2016
5.3
Figure 2: Housing interconnection
Long side of GMYA7 housing
Use the mounting aid to connect the bot-
tom parts of the housing and fit these to-
gether.
Open GMYA7 housing
Loosen screws a few turns.
Use a screwdriver to press down the
snap-in hooks (A) and raise the upper
part of the housing slightly.
Raise the upper part of the
housing max. 1 cm and
slide up
Close GMYA7 housing
Attach the upper part of the housing at
the top to the housing bottom and press
down until the two snap-in hooks snap in.
Tighten the screws and fit the seals (B)
to complete the assembly.
Inner view of GMYA7 housing
A
Snap-in hook
B
Printed circuit board
C
Screw terminal
D
Tamper contact switch
E
Mounting screw for printed circuit
board
F
Retaining clips
G
Holes for mounting
H
Safety screw for back tamper con-
tact
I
Break-out point for cable entry
